Table of Contents
Advertisement
6.3
Setting rear link angles
The rear link angle is selected by choosing corresponding holes in the white ANGLE SELECT
sections of the rear rigging on each side (0°, 0.5°, 1°, 1.5°, 2°, 3°, 4°, 5°, 6°, 8°, 10°) as
determined by LAPS 3. Unless the rigging is locked into a rigid configuration by secondary pins
in the lower black ANGLE LOCK sections, the elements always default to 0° when lifted. Use
of the bottom pull-up grid accessory enables the array to be easily compressed with each
element stopping at its pre-selected splay angle. Smaller arrays may be rigidly pinned by lifting
the rear of each box until it hits the pre-selected angle stop, then inserting a second pin per
side into the appropriate hole in the ANGLE LOCK section. There is no fumbling for pin holes
because when lifted, the rigging will stop at the pre-selected position.
Figure 6.2: X1/X2 Rigging Hardware
Rear link angle selection
1.
2.
3.
▪
Electro-Voice
PIN PARK is used to park the unused pin.
RETRACT LOCK is used to lock the link bar in stored position.
ANGLE SELECT (in the white section) is used to set the desired splay angle from the
report from LAPS 3. This is used for both fixed-pin angles and rear-rigging compression
pull up.
0.5, 1°, 1.5, 2°, 3°, 4°, 5°, 6°, 8°, and 10° are the available angles for selection. For a 0º
angle, use the 0º angle hole in the Angle Lock section below.
Installation Manual
en
17
2015.04 | 02 | F.01U.310.953
Hide quick links:
Advertisement
Table of Contents
