Understanding Display Messages - Samsung CLP-600 Series User Manual

Problem
Back of
• The transfer roller may be dirty. See "Cleaning the
printouts are
Inside of the Printer" on page 6.8.
dirty
• Check for leaking toner. Clean the inside of the
printer.
Solid Color or
• The toner cartridge may not be installed properly.
Black pages
Remove the toner cartridge and reinsert.
• The toner cartridge may be defective and need
replacing. Install a new toner cartridge.
• The printer may require repair. Contact a service
A
representative.
Loose toner
• Clean the inside of the printer.
• Check the paper type and quality. See "Paper
Specifications" on page 10.1.
• Install a new toner cartridge. See "Replacing Toner
Cartridges" on page 6.4.
• If the problem persists, the printer may require
repair. Contact a service representative.
Character
Character voids are white areas within characters that
Voids
should be solid black:
• You may be printing on the wrong surface of the
paper. Remove the paper and turn it over.
A
• The paper may not meet paper specifications. See
page 10.1.
Horizontal
If horizontally aligned color or black streaks or
stripes
smears appear:
• A toner cartridge may be installed improperly.
AaBbCc
Remove the toner cartridge and reinsert.
• A toner cartridge may be defective. Install a new
AaBbCc
toner cartridge.
AaBbCc
• If the problem persists, the printer may require
AaBbCc
repair. Contact a service representative.
AaBbCc
Solution
Solving Problems
Problem
Curl
If the printed paper is curled or paper does not feed
into the printer:
• Turn the stack of paper over in the paper tray. Also
try rotating the paper 180° in the tray.
Understanding Display
Messages
Messages appear on the SmartPanel program window or the
control panel display (CLP-600N only) to indicate the printer's
status or errors. Refer to the tables below to understand the
messages' meanings and correct the problem if necessary.
Messages and their meanings are listed in alphabetical order.
N
: When you call for service, it is very helpful to tell the
OTE
service representative the display message.
Message
Adjusting Auto color reg is in the
Registration process. Please wait.
ADC Not A problem has
Confirm Error occurred in the ADC in
the printer.
Cover Open The top cover or
access door is open.
Install
Otherwise, the paper
Transfer Belt
transfer belt is not
installed in the printer.
[Color] Toner The corresponding
Empty toner cartridge in your
printer is empty, and
the printer will stop
printing until a new
toner cartridge is put
into the printer.
Dev. Motor error A problem has
occurred in the
development motor of
the printer.
7.14
Solution
Status Do this...
Till the message is turned to be
Ready, please wait up to 120
seconds referring to page 3.4
Contact a service
representative.
Close the top cover or access
door firmly. Otherwise, Install
the paper transfer belt.
Replace the corresponding
toner cartridge with a new one.
See page 6.4.
Unplug the power cord and
plug it in again. If the problem
persists, call for service.