Samsung CLP-600 Series User Manual page 63

13
Repeat step 12 to complete the address from the 1st byte
to the 4th byte.
14
To select other parameters, such as the Subnet Mask or
Gateway, press the scroll button (
Enter button ( ).
15
Repeat steps 12 through 13 to configure the other TCP/IP
parameters.
16
Press the On Line/Continue button (
ready mode.
Dynamic Addressing (BOOTP/DHCP)
To assign the TCP/IP address automatically by the server, take
the following steps:
1
In ready mode, press the Menu button (
"Network" on the bottom line of the display. Press the
Enter button ( ) to access the menu.
2
Press the Enter button (
displays on the bottom line.
3
Press the scroll button (
and press the Enter button (
4
Press the Upper Level button (
button ( ).
5
Press the Enter button (
6
Press the scroll button (
and press the Enter button (
7
Press the Upper Level button (
button ( ).
8
Press the Enter button (
displays.
9
Press the scroll button (
and press the Enter button (
10
To assign the address from the BOOTP server, press the
Enter button ( ) when "BOOTP" displays.
11
Press the On Line/Continue button (
ready mode.
or ). Press the
) to return to
) until you see
) when "Config Network"
or ) until "Yes" displays,
).
), then use the scroll
) when "Config TCP" displays.
or ) until "Yes" displays,
).
), then use the scroll
) when "IP Get Method"
or ) until "DHCP" displays,
).
) to return to
Using Your Printer on a Network (CLP-600N only)
Configuring IPX Frame Types
On IPX/SPX protocol networks (for example, Novell NetWare),
the format of the network communication frames must be
specified for the printer. In most cases, you can keep the 'Auto'
default setting. However, you can manually set the frame type
format, if required.
• Auto (default): Automatically senses and limits the frame
type to the first one detected.
• EN_8022: Limits the frame type to IPX over IEEE 802.2
with IEEE 802.3 frames. All others will be discarded.
• EN_8023: Limits the frame type to IPX over IEEE 802.3
frames. All others will be discarded.
• EN_II: Limits the frame type to IPX over Ethernet Frames.
All others will be discarded.
• EN_SNAP: Limits the frame type to IPX over SNAP with
IEEE 802.3 frames. All others will be discarded.
Note that the IPX/SPX protocol must be enabled in the
Netware menu before you can configure frame types. See
"Setting Network Protocols" on page 8.2.
Take the following steps to change the frame type format:
1
In ready mode, press the Menu button (
"Network" on the bottom line of the display. Press the
Enter button (
2
Press the Enter button (
displays on the bottom line.
3
Press the scroll button (
the bottom line. Press the Enter button (
4
Press the Upper Level button (
5
Press the scroll button (
displays on the bottom line. Press the Enter button (
6
Press the scroll button (
the bottom line. Press the Enter button (
7
Press the Upper Level button (
button (
8
Press the Enter button (
displays.
9
Press the scroll button (
the bottom line. Press the Enter button (
10
Press the Upper Level button (
button (
11
Press the Enter button (
displays.
8.3
) to access the menu.
) when "Config Network"
or ) until "Yes" displays on
).
or ) until "Netware"
or ) until "On" displays on
), then use the scroll
).
) when "Config Netware"
or ) until "Yes" displays on
), then use the scroll
).
) when "IPX Frame Type"
) until you see
).
).
).
).