Belt Tension & Replacement - Schwinn S.C. 7 Service Manual

Belt Tension & Replacement
1. Remove the rubber chainguard cap.
2. Remove the screws from the user right chainguard (inset).
3. Use a Phillips screw driver and 5mm hex key to remove the
screws securing the user left Chainguard to the bike.
4. Rotate the chainguard downward to remove
5. Remove the rubber cap from the user left side.
6. Use a 19mm socket to remove the axle bolts and axle spac-
ers on both sides of the flywheel.
NOTE: The axle spacers are left-right specific.
7. Use a small crescent wrench to loosen the tension screw
lock nuts on both sides of the flywheel.
8. Use a 3mm allen key to remove the left and right tension
screws.
Page 7