Table of Contents
Advertisement
INSTALLATION
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
WARNING:
ISK OF
NJURY
Installation procedures must
of all applicable electrical
codes. Failure can result in
personal injury and property
damage.
WARNING:
RE HAZARD
combustible materials near
the appliance.
UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all
Appliance before connecting electrical power or otherwise performing
any installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet t
installation.
Read and understand all labels and diagrams attached to the
appliance.
Carefully account for all components and accessories before
appliance for later use. These items must be installed before operating
the appliance.
1 ea. FIRE SUPPRESSION AGENT (ANSULEX® Low pH
See Material Safety Data Sheet, page 28.
1 ea. FIRE SUPPRESSION MEDIA TANK
1 ea. FIRE SUPPRESSION
1 ea. GREASE BAFFLE
1 ea. FILTER PACK ASSEMBLY
1 ea. PRE-FILTER HOLDER with PRE-FILTER
1 ea. GREASE CUP
1 ea. GREASE TROUGH
2 ea. 6" SIDE SPACERS
1 ea. LITERATURE PACKAGE
Additionally:
1 ea. FAN BAFFLE
2 ea. RACK SUPPORTS
3 ea. CONVECTION OVEN RACKS
SETUP
material is recommended.
Refer to the Installation Instruction Sheet for required clearances.
Maintain required clearances between the appliance and adjacent
combustible surfaces. Verify 6" left and right side clearances to
combustible construction. This appliance requires a minimum of 8 ft
(96")
IMPORTANT:
the appliance.
Verify that the VENTILATOR HOOD ASSEMBLY is properly and
installation procedure.
If a remote manual pull station is to be installed, replace the rear
casters with legs.
8
TANK CHARGING CARTRIDGE
t
Advertisement
Table of Contents
