Output Setting Of Relay Contact Signal; Output Setting Of Alr Sentence - JRC JMA-933B Installation Manual

5.4.10.3

Output Setting of Relay Contact Signal

The output port of the relay contact signal is set.
The setting not output or the output terminal fixation can be set.
1) Open the Alarm.
2) Left-click the Relay Output.
3) Set each output relay contact signal.
The contact signal is output to the terminal set to set the name of the output terminal.
・TT:
・System:
・Navigation:
・CPA ACK:
・Alarm ACK:
5.4.10.4

Output setting of ALR sentence

Alarm information added to the ALR sentence is set.
1) Open the Alarm.
2) Left-click the ALR Output.
3) Set each output alarm.
・TT Alarm:
sentence.
・System Alarm:
・Navigation Alarm:
Setting of terminal that outputs dangerous ship alarm. (ARPA ALR)
Setting of terminal that outpus system alarm. (SYS ALR)
Setting of terminal that outpus nagivation alarm. (OP CONTACT)
Setting of terminal that outpus watchman timer reset signal (WMRST OUT)
Setting of terminal that outpus alarm ACK. (ACK OUT)
Setting that adds information on dangerous ship alarm to ALR
Setting that adds information on system alarm to ALR sentence.
Setting that adds information on navigation alarm to ALR sentence.
5-50