Dometic PR2500 Installation Manual page 15

PR2000_PR2500-I-16S.book Seite 15 Donnerstag, 5. Oktober 2017 10:15 10
PR2000, PR2500
A
NOTICE!
• If the vehicle-specific installation manual specifies through bolting,
• If there is insufficient space above the door after the awning is
• The cables and cabinets in the interior of the vehicle may not be
I
NOTE
• Ensure the user of the vehicle is aware that the screws on the rear hinge
6.3 Installing the awning
During installation, observe the following general information:
• The mounting rails are bolted to the vehicles in the area of the rear hinge. In
addition, they are glued with installation adhesive (e.g. Sikaflex
product) to ensure the load is evenly spread and an optimal level of protection
from moisture is maintained.
• Observe the sealant manufacturer's instructions.
• An illustrated instruction manual that covers each type of installation is enclosed
with every vehicle-specific installation kit. As with the installation instruction
manual, this manual must be observed closely and complied with.
• Before installation, check the access to the screw joints. Make sure no cables or
cabinets are damaged when drilling.
• Contact your local service partner if you wish to have an angle of inclination
different to the default setting.
• If you wish to use an awning tent with the awning at a later date, ensure that the
vent windows and hatches of the erected tent remain accessible when choosing
the awning size and installation position (fig. 4, page 4).
• Clean the adhesive surfaces on the mounting rail and the wall.
• Prepare the adhesive surfaces with the primer.
EN
ensure the inner screw joints are accessible.
mounted, the door must remained closed when retracting or
extending to avoid the door making contact with the arms or the
front panel.
The required space depends on the design of the door (door width,
swing or sliding door) as well as the set awning angle of inclination
(fig. 2, page 4).
damaged by drilling the holes.
(fig. 3, page 4) must be tightened up (see operating manual). The
arms must not bear any load. This must be done by the service partner.
Installing the awning
®
-252 or a similar
15