Makita UC3541A Instruction Manual page 6

･
Chain oil
･
Chain brake released
･
Chain brake applied
･
Prohibited!
･
Only for EU countries
Do not dispose of electric equipment
together
material!
In observance
Directive,
Electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for cutting lumbers and logs.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause
voltage fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.29 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected
with a fuse or protective circuit breaker having slow
tripping characteristics.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.5 dB (A)
Wear ear protection
with household
of the European
on Waste Electric
Equipment and
environmentally compatible
noise level determined
) : 90.3 dB (A)
pA
) : 101.3 dB (A)
WA
Vibration
The vibration
determined according to EN60745:
Work mode : cutting wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
waste method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
and used in a preliminary assessment of exposure.
its
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
ENE085-1
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
ENF002-2
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
ENF100-1
Designation of Machine:
Chain Saw
Model No./ Type: UC3041A, UC3541A, UC4041A
Specifications: see "SPECIFICATIONS" table.
Conforms to the following European Directives:
2000/14/EC, 2006/42/EC
They are manufactured in accordance with the following
Standard or standardized documents:
EN60745
The Technical file in accordance with 2006/42/EC is
available from:
ENG905-1
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
The conformity assessment procedure required by
Directive 2000/14/EC was in Accordance with annex V
Measured Sound Power Level: 102.2 dB (A)
Guaranteed Sound Power Level: 104 dB (A)
000331
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
6
total value (tri-axial
2
) : 4.7 m/s
h
2
26.4.2013
Yasushi Fukaya
Director
ENG900-1
vector sum)
ENG901-1
ENH021-8