Replacing Fryer Components; Replacing The Controller Or Computer; Replacing The Thermostat - Frymaster 47 Series Service & Parts Manual

1.7 Calibrating the Thermostat Control (cont.)
The thermostat adjusting screw must not be moved while installing the flexible
13. Install the solid metal extension shaft on the end of the flexible shaft with the stop pin at the 12
o'clock position. Ensure the stop pin and setscrews are tight to prevent slippage.
14. Reinstall and secure the fryer control panel. Loosen the temperature dial plate screws and rotate
the dial until the 325°F (162°C)-index mark is at the 12 o'clock position, then retighten the
screws.
15. Reinstall the thermostat knob with its pointer aligned with the 325°F (162°C)-index mark on the
temperature dial plate. Tighten the thermostat knob set screws to prevent slippage.

1.8 Replacing Fryer Components

1.8.1 Replacing the Controller or Computer

1. Disconnect the fryer from the electrical supply.
2. Unscrew the two control panel screws. The control panel is hinged at the bottom and will swing
open from the top.
3. Unplug the fryer wiring harness from the back of the controller/computer.
4. Remove the controller/computer by lifting it from the hinge slots in the fryer control panel frame.
5. Reverse the procedure to install a new controller/computer.

1.8.2 Replacing the Thermostat

1. Disconnect the fryer from the electrical supply.
2. Drain cooking oil/shortening below level of probe.
3. Remove thermostat knob. Remove the screws from the upper left and right corners of the control
panel. The control panel is hinged at the bottom and will swing open from the top.
4. Disconnect the wiring plug(s)from the component shield/control box.
5. Remove the control panel from the fryer by disengaging its tabs from the hinge slots in the
mounting frame.
47 SERIES GAS FRYERS
CHAPTER 1: SERVICE PROCEDURES
CAUTION
extension shaft.
1-14