Adjusting Ceramic Burner Target Spacing And Alignment; Adjusting The Pilot Flame - Frymaster 47 Series Service & Parts Manual

1.5 Adjusting Ceramic Burner Target Spacing and Alignment

Drain the frypot or remove the handle from the drain valve before proceeding further.
Proper spacing of the top edge of the ceramic burner targets is ¾-inch (13 mm) from the frypot side.
To adjust target spacing, bend the brackets to which they are attached away or toward the frypot to
the proper distance. (A length of board of the proper thickness is useful as a gauge to verify spacing
and alignment.) Proper spacing of the rear ceramic burner target is 1 inch from the frypot back.
¾-inch
(side)
Master Jet
burner target
alignment.

1.6 Adjusting the Pilot Flame

1. Remove the cap from the pilot adjustment screw hole on the gas valve.
2. Using a small, flat-tipped screwdriver, turn the pilot adjusting screw counterclockwise to
increase length of flame or clockwise to decrease length of flame. Adjust to obtain a flame from
1 inch to 1½ inches long.
3. Reinstall the pilot adjustment screw cap.
47 SERIES GAS FRYERS
CHAPTER 1: SERVICE PROCEDURES
DANGER
Frypot
1-12
1-inch
(rear)