Mira Discovery Installation & User Manual page 13

Foam Seal
Backplate
Nut
Olive
Copper Pipe
Clip
2.7. Drill the two RAC wallplate fixing
holes, if necessary make a recess
approximately 6 mm deep to accept
the RAC wallplate. Plug the two
fixing holes.
2.8. Fix the RAC wallplate to the wall
with the two fixing screws.
2.9. Temporarily fit the two fixing screws
to the RAC wallplate. This will
prevent the holes from becoming
blocked with plaster and grout.
2.10. Finish the surface of the wall as
required ensuring the pipework is
protruding by at least 20mm.
2.11. Remove the two fixing screws.
2.12. Make sure that the foam seal abuts
the finished wall surface. Place the
backplate against the foam seal
and use the two screws supplied to
fix the backplate to the wall. Ensure
that the 'O' seal is fitted to the inside
of the backplate nut.
2.12. Fit the compression olive and
backplate nut. Carefully tighten to
seal.
2.13. Ensure the external 'O' seal is fitted
to the backplate nut. Ensure the
clips on the elbow are fully engaged
with the backplate.
2.16. Locate the RAC shroud over the
elbow. Carefully push the shroud
until it engages with the lugs on the
backplate.
2.17. To complete the installation fit the
hose, slide bar and handset.
13