Table of Contents
Advertisement
iRADV C7580i/C7570i/C7565i Advance Maintenance Guide
Procedure
M14
Multifunction professional Puncher- A1
DIE Maintenance
continued.
M15
Multifunction professional Puncher- A1
Clean any loose chads
inside the Pro Punch
Do not need to do this every service
call. Recommended at 500K.
depending on customer use and
environment.
Detail
Die Set Shoulder Bolts Lubrication.
1. Lubricate with high quality Teflon-based
grease.
2. Apply grease to Shoulder Bolts and
Springs [1]
3. Wipe up any excess grease.
1. Occasionally remove the covers and remove paper dust and chips.
Paper dust can accumulate throughout the punch including around the
motor and other electrical components. Use vacuum cleaner if possible.
A small paintbrush can also be used but extreme care should be used
around electrical components.
2. Clean non-electrical components with alcohol, an approved cleaner,
or soft cloth moistened with mild detergent and warm water.
3. Clean the Rollers with alcohol.
CAUTION: Make sure you disconnect the Professional Puncher from its
power source before cleaning. Failure to observe this warning could
result in death or injury.
Base Cleaning : Chips and paper dust falls to the bottom of the punch.
Clean every service call. ( Clean with a vacuum cleaner )
Chip Bin Cleaning: Empty out the bin every service call. Clean, especially
at the holes on the sides of the bin
Note
Every
inspected and lubricated
DIE
# of cycles punched with the
Die set that is currently
installed in the machine.
Empty Hole Punch Waste
Remove dirt, paper dust,
NCR residue and toner from
the Pro Punch and Finisher
rollers
Clean
Time
200K
copies should be
Cycles: This displays the
Die Guide Cleaning:
every
500k
cycles
1. Remove the Die Set
and clean the guide[1]
with a vacuum cleaner.
Hide quick links:
Advertisement
Table of Contents
