Installer Setup; Setting Temperature - Honeywell T7300E Series Installation Instructions Manual

T7300E SERIES 2000 COMMERCIAL MICROELECTRONIC HEAT PUMP THERMOSTAT
ENTER OCCUPIED
PROGRAM MODE
RETURNS TO
NORMAL
OPERATIONS
Program
SET OVERRIDE
Temporary
Occupied
TEMPERATURE
OFFSET AND
ACTIVATE
Continuous
TEMPORARY
Unoccupied
OVERRIDE
ENTER HOLD MODE
Setting System and Fan (select models)
The system default setting is Heat. The fan default is set
so the fan operates continuously in Occupied and Recovery
mode and with the heating or cooling equipment in
Unoccupied mode. Use the System and Fan keys to
change the settings.
The system settings are:
Em Heat (Q7300C,D): Emergency heat relay is on
continuously. Thermostat cycles highest stage of
heat. Cooling system is off. Compressor is
de-energized.
Heat: Thermostat controls the heating.
Off: Both the heating and cooling are off.
Cool: Thermostat controls the cooling.
Auto: Thermostat automatically changes between
heating and cooling operation depending on the
indoor temperature.
The fan settings are:
On: Fan operates continuously.
Auto: Equipment controls fan.

Setting Temperature

Refer to Table 1 for the default temperature setpoints. See
Owners Guide form number 63-4356 for complete
instructions on changing the setpoints.
Table 1. Default Temperature Setpoints.
Control Occupied
Heating 70°F (21°C)
Cooling 78°F (25.5°C)
62-0124—3
ENTER UNOCCUPIED
PROGRAM MODE
SET CURRENT DAY OR
PROGRAM DAY
Mon
Occupied
System
Heat
Set Program
Run Occupied Unoccupied
Start Time Start Time
Set Current Clear
Day/Time Start Time
SET CURRENT
DAY AND TIME
CLEAR PROGRAM PERIOD
Fig. 2. Thermostat key locations and descriptions.
Unoccupied
55°F (13°C)
90°F (32°C)
SET OCCUPIED
TEMPERATURE
SETPOINTS
AM
Room
Fan
Auto
Set Temperature
Occupied Unoccupied
Day Temp Temp
Heat/Cool
Copy Settings
System Fan
SELECT
SYSTEM
OPERATION
COPY ONE
PROGRAMMED DAY
TO ANOTHER DAY

INSTALLER SETUP

NOTE: For most applications, the thermostat factory-
settings do not need to be changed. Review the
factory-settings in Table 2 and if no changes are
necessary, go to the Installer Self-Test section.
The Installer Setup mode is used by the installer to
customize the thermostat to specific systems. Installer
Setup numbers are listed in Table 2. The table includes all
the configuration options available.
A combination of key presses are required to use the
Installer Setup feature.
— To enter the Installer Setup mode, press and hold the
Heat/Cool Settings key with both the increase
decrease keys until the first number is displayed.
All display segments appear for approximately three
seconds before the number is displayed. See Fig. 3
and 4.
2
SET UNOCCUPIED TEMPERATURE
SETPOINTS AND SCROLLS
THROUGH INSTALLER SETUP
AND SYSTEM TEST
INCREASE
TEMPERATURE
Change
OR TIME SETTING
Time/Temp
SELECT FAN
CHANGE BETWEEN HEATING
OPERATION
AND COOLING SETPOINTS
AND SCROLLS BACKWARDS
THROUGH INSTALLER SETUP
NUMBERS AND SYSTEM TEST
DECREASE
TEMPERATURE
OR TIME SETTING
M10233A
and