Exmark QUEST QZS708GEM50200 Operator's Manual page 44

Maintenance
Note: Ensure the oil filter gasket touches the
engine, then an extra 3/4 turn is completed.
Note: Dispose of the used oil at a recycling
center.
6. Slowly pour approximately 80% of the specified
oil into the filler tube—use oil recommended in
the Checking the Engine Oil Level–Exmark
452cc Engine section.
Figure 40
g027477
7. Check the oil level; refer to Checking the
Engine Oil Level–Exmark 452cc Engine
section.
8. Start the engine and check for leaks.
Changing the Engine Oil-Exmark
708cc Engine
Service Interval: After the first 5 hours
1. Park the machine so that the drain side is slightly
lower than the opposite side to ensure the oil
drains completely.
2. Start the engine and let it run until warm. This
warms the oil so it drains better.
3. Disengage the blade control switch and ensure
the parking brake is engaged.
4. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
44
Figure 41
Every 100 hours (change
it more often under a
heavy load or in high
temperatures)(Exmark
708cc Engine).
g027484