Exmark QUEST QZS708GEM50200 Operator's Manual page 40

Maintenance
Check the air cleaner daily or before starting the
engine. Check for a buildup of dirt and debris around
the air cleaner system. Keep this area clean. Also
check for loose or damaged components. Replace all
bent or damaged air cleaner components.
Note: Operating the engine with loose or damaged
air cleaner components could allow unfiltered air into
the engine causing premature wear and failure.
Note: Service the air cleaner more often under
extremely dusty, dirty conditions.
Removing the Elements:
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers out to the neutral
lock position, engage parking brake, stop the
engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Clean around the air cleaner cover to prevent dirt
from getting into the engine and causing damage.
4. Lift the cover and rotate the air-cleaner assembly
out of the engine (see Figure 31 and Figure 32).
Figure 31
5. Separate the foam and paper elements.
Cleaning the Foam and Paper Elements:
Foam Element:
Wash the foam element with water.
g027800
Important: Replace the foam element if it is
torn or worn.
Paper Element:
1. Lightly tap the element on a flat surface to remove
dust and dirt.
2. Inspect the element for tears, an oily film, and
damage to the seal.
Important: Do not clean the paper element
with pressurized air or liquids, such as
solvent, gas, or kerosene. Replace the paper
element if it is damaged or cannot be cleaned
thoroughly.
40
Figure 32
Figure 33
g027801
g027802