Set Features Command - Seagate Skyhawk Surveillance 512E Product Manual

www.seagate.com
1.4.3.4

Set Features command

This command controls the implementation of various features that the drive supports. When the drive receives this
command, it sets BSY, checks the contents of the Features register, clears BSY and generates an interrupt. If the value
in the register does not represent a feature that the drive supports, the command is aborted. Power-on default has the
read look-ahead and write caching features enabled. The acceptable values for the Features register are defined as
follows:
Table 13 Set Features command values
02 Enable write cache (default).
H
03 Set transfer mode (based on value in Sector Count register).
H
Sector Count register values:
00 Set PIO mode to default (PIO mode 2).
H
01 Set PIO mode to default and disable IORDY (PIO mode 2).
H
08 PIO mode 0
H
09 PIO mode 1
H
0A PIO mode 2
H
0B PIO mode 3
H
0C PIO mode 4 (default)
H
20 Multiword DMA mode 0
H
21 Multiword DMA mode 1
H
22 Multiword DMA mode 2
H
40 Ultra DMA mode 0
H
41 Ultra DMA mode 1
H
42 Ultra DMA mode 2
H
43 Ultra DMA mode 3
H
44 Ultra DMA mode 4
H
45 Ultra DMA mode 5
H
46 Ultra DMA mode 6
H
10 Enable use of SATA features
H
55 Disable read look-ahead (read cache) feature.
H
82 Disable write cache
H
90 Disable use of SATA features
H
AA Enable read look-ahead (read cache) feature (default).
H
F1 Report full capacity available
H
NOTE
Seagate SkyHawk Serial ATA Product Manual, Rev. B
At power-on, or after a hardware or software reset, the default values of the
features are as indicated above.
Serial ATA (SATA) interface
49