Parameters/Address Space; Parameters - Siemens DQ 16x24VDC/0.5A HF User Manual

Parameters/address space

4.1

Parameters

DQ 16x24VDC/0.5 HF parameters
When you assign the module parameters in STEP 7, you use various parameters to specify
the module properties. The following table lists the configurable parameters. The effective
range of the configurable parameters depends on the type of configuration. The following
configurations are possible:
● Central operation with a S7-1500 CPU
● Distributed operation on PROFINET IO in an ET 200MP system
● Distributed operation on PROFIBUS DP in an ET 200MP system
For parameter assignment in the user program, the parameters are transferred to the
module using the WRREC instruction (parameter assignment in RUN) and data sets; see
section Parameter assignment (Page 36)
Table 4- 1 Configurable parameters and their defaults
Parameters
Diagnostics
No supply voltage L+
•
Short circuit to ground
•
Maintenance switching
•
cycles
Switching cycle counter
•
Wire break
•
17
Range of values Default
setting
Yes/No No
Yes/No No
Yes/No No
Yes/No No
Yes/No No
Parameter
assignment
in RUN
Integrated in the
hardware catalog
as of STEP 7,
V13 SP1 or GSD
file PROFINET IO
Yes Channel*
Yes Channel*
Yes Channel
(as of V15.0 with
HSP0247)
Yes Channel
(as of V15.0 with
HSP0247)
Yes Channel*
Digital output module DQ 16x24VDC/0.5A HF (6ES7522-1BH01-0AB0)
Scope with configuration software,
e.g., STEP 7 (TIA Portal)
GSD file
PROFIBUS DP
Channel group
(CH0 to CH7, CH8
to CH15)
Channel group
(CH0 to CH7, CH8
to CH15)
---
---
Channel group
(CH0 to CH7, CH8
to CH15)
Manual, 06/2018, A5E35683409-AC
4