Table of Contents
Advertisement
B.
With the large brush provided, sanitize the rear
of the freezing cylinder by dipping the brush in
the sanitizing solution and brushing the rear of
the cylinder.
3.11 ASSEMBLY OF MACHINE
To assemble the machine parts, refer to the following steps:
Petrol Gel sanitary lubricant or equivalent must be
used when lubrication of parts is specifi ed.
The United States Department of Agriculture and
the Food and Drug Administration require that lubri-
cants used on food processing equipment be certi-
fi ed for this use. Use lubricants only in accordance
with the manufacturer's instructions.
A.
Assemble all o-rings onto the parts dry, without
lubrication. Then apply a thin fi lm of sanitary
lubrication to the exposed surfaces of the o-rings.
Also apply a thin fi lm of sanitary lubricant to the
inside and outside of the front auger support
bushing, and to the inside and outside of stator
support bushing.
B.
Assemble the rear seal onto the auger with the
large end to the rear. Be sure the o-ring is in place
before installing the rear seal (Refer to Figure
3-8).
C.
Put a small amount of spline lubricant on the hex
end of the auger shaft. A small container of spline
lubricant is shipped with the machine.
Torque
Rod
Owner's Manual #513613
NOTE
NOTE
Auger
Support
Stator Bar
Bushing
Stator Bar
Front O-Ring
Figure 3-9 Door and Stator Assembly
D.
Install the plastic auger blade onto the auger.
E.
Push the auger into the freezing cylinder and
rotate it slowly until the auger engages the drive
shaft.
F.
Insert the spigot body into the front door.
Press the o-rings against the spigot body when
inserting it into the front door to prevent damage.
G.
Turn the spigot body until the ice breaker bar can
be inserted. Insert the breaker bar and rotate the
spigot body 90
H.
Install the auger support bushing onto the front
door so the beveled edge of the bushing is against
the door.
I.
Install the white stator support bushing onto the
rear of the stator bar and insert stator into spigot.
J.
Insert the torque rod. The rod should be placed
through the hole in the stator bar.
K.
Install the front door onto the machine.
When installing the door onto the machine, the
torque rod must be placed in the center of the metal
torque actuator arm
L.
Install the knobs on the machine studs.
M.
Look for the proper seal between the freezing
cylinder, quad ring, and front door
Stator Bar
Bushing
Stator Bar
Rear O-Ring
12
NOTE
NOTE
Quad
Ring
E112/F112 Model Machines
Advertisement
Table of Contents
