Connecting To A Tv (Interlace) - Samsung DVD-FP580 Owner's Instructions Manual

C
O N N E C T I O N S

Connecting to a TV (Interlace)

- Connecting to your TV using Component video cables. The 480i resolution is possible with this
connection.
- This is the best available connection if your TV is not capable of receiving a Progressive Scan
signal.
- You will enjoy excelllent quality and accurate color reproduction images. Component video
separates the picture element into black and white(Y), blue(P
and clean images. (Audio signals are delivered through the audio output.)
1
Using Component video cables (not included), connect the
COMPONENT VIDEO OUT jacks on the rear of the DVD player
to the COMPONENT IN jacks of your
2
Using the audio cables, connect the AUDIO (red and white)
OUT jackls on the rear of the DVD player to the AUDIO (red
and white) IN jacks of your TV.
Turn on your DVD player and TV.
3
Set the Video Output to I-SCAN in the Display Setup menu.
(See pages 50 to 52)
You can also use the VIDEO SEL. button to change the
Output mode. (See page 16)
4
Press the input selector on your
Component signal from the DVD player appears on the TV
screen.
Note
- If you want to connect to an Amplifier, please refer to the Amplifier connection page. (See pages 17 to 18)
- The component jack of your TV may be marked "R-Y, B-Y, Y" or "Cr, Cb, Y" instead of "P
depending on the manufacturer. The number and position of the jacks may vary depending on the TV set.
Please refer to the user's manual of your TV.
TV.
Video
TV remote control until the
ENG-15
), red(P ) signals to present clear
B R
RED BLUE GREEN
RED
WHITE
Audio Cable
(Included)
WHITE
RED
GREEN
RED BLUE
, P
R
Component cable
(not included)
, Y"
B