Table of Contents
Advertisement
C
O N N E C T I O N S
Connecting to a TV (Interlace)
-
Connecting to your TV using Component video cables.-
your TV is not capable of receiving a Progressive Scan signal.
- You will enjoy excellent quality and accurate color reproduction images. Component video
separates the picture element into black and white(Y), blue(P
and clean images. (Audio signals are delivered through the audio output.)
1
Using Component video cables (not included), connect the
COMPONENT VIDEO OUT jacks on the rear of the DVD player
to the
COMPONENT IN jacks of your
2
Using the audio cables, connect the AUDIO (red and white)
OUT
jackls on the rear of the DVD player to the AUDIO (red
and white) IN
jacks of your
TV.
Turn on your DVD player and TV.
3
Set the
Video Output to
I-SCAN in the Display Setup menu.
(See pages 51 to 53)
You can also use the
VIDEO SEL. button to change the
Output mode. (See page 16)
4
Press the input selector on your
Component signal from the DVD player appears on the TV
screen.
Note
-
If you want to connect to an Amplifier, please refer to the Amplifier connection page. (See pages 17 to 18)
- The Component jacks of your TV may be marked "R-Y, B-Y, Y" or "Cr, Cb, Y" instead of "P
depending on the manufacturer. The number and position of the jacks may vary depending on the TV set.
Please refer to the user's manual of your TV.
TV.
Video
TV remote control until the
ENG-15
This is the best available connection if
), red(P
) signals to present clear
B
R
WHITE
RED
RED
Audio Cable
(Included)
WHITE
RED
BLUE GREEN
RED
GREEN
BLUE
Component cable
(not included)
, P
, Y"
R
B
Advertisement
Chapters
Table of Contents
