Hobart ecomax Use And Maintenance Manual page 10

3.
OPERATING FUNCTIONS
When using a "Recipe" with several processing phases, the appliance ends
the cooking cycle at the end of the last memorized phase (see 7.1. 7.1 Re-
cipe Index).
When using the appliance in MANUAL mode, the operator must set all of
the desired cooking parameters each time (see 6. Cooking).
When you use the equipment in CORE PROBE mode during manual coo-
king and/or recipe phase, the MAIN core probe is always enabled (internal,
if both present, or the one installed).
3.4 Software language setup
The oven is set to Italian. Upon first start-up, the following will be displayed:
Example: Display 1 shows "LINGUA"
Display 2 shows "P 01"
Display 3 shows "ITA"
To select the desired language press the "TIME" key (Fig 2/E - Display 4)
and use keys "PLUS" and "MINUS" (Fig 2/B) to select the language. Press
the key "TIME" (Fig 2/E) to confirm.
Press the key "ENTER" (Fig.2/A) twice for 3 seconds to save and exit the
function.
With the electrical power supply stopped upstream of the ap-
pliance for longer than 100 hours, reset the software language.
3.5 Description of stop modes
The description of the various stop modes are described as follows:
In the event of imminent danger, close all of the locking devi-
ces connected to the appliance (Electrical - Water - Gas).
1. Emergency stop
In situations or circumstances that could be dangerous, shut off the electri-
city upstream of the oven.
Restarting:
To restart the production cycle, contact the authorised service centre.
2. Stoppage during a work phase
To stop the operation of the production cycle, proceed as follows:
Press "ENTER" (Fig. 2/A) to stop the operations,
In "POST." or "WASHING" mode, press "ENTER" (Fig. 2/A) for 3 seconds.
Restarting:
To restart the production cycle after a shutdown, follow the procedure given
in: Daily activation
3. Stop due to opening the door during operation
The appliance can be immediately stopped by opening the door.
Restarting:
After having resolved the issue that made it necessary to open the door, an
authorised operator can restart the appliance by closing the door.
The appliance has hot surfaces: glass, door and front side. When
the oven is hot, open the door carefully, standing to the side of
the appliance to avoid direct heat: the setam accumulated may
cause burns.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
- 10 - 10
Display 1
Display 2
Display 3
Display 4 E
B
A
Fig.2