Recommended Adjustments - Grizzly G1021X2 Owner's Manual

to test run machine:
1. Clear all setup tools and loose objects away
from machine.
2.
push Stop button in.
3.
Connect machine to power supply.
4.
twist Stop button clockwise until it springs
out (see figure 17). this resets the switch so
the machine can start.
figure 17. resetting the switch.
5. press Start button to turn machine ON.
Verify motor starts up and runs smoothly
without any unusual problems or noises.
6. press Stop button to turn machine OFF.
7.
Without resetting Stop button, try to start
machine by pressing the Start button. the
machine should not start.
— if the machine does not start, the Stop
button safety feature is working correctly.
Congratulations! test run is complete.
— if the machine does start with the Stop
button pushed in, immediately disconnect
power to the machine. the Stop button
safety feature is not working correctly and
must be replaced before further using the
machine. Call tech Support for help.
-22-
Recommended
Adjustments
the adjustments listed below have been per-
formed at the factory. however, because of the
many variables involved with shipping, we recom-
mend that you verify the adjustments to ensure
the best possible results from your new machine.
Step-by-step instructions for these adjustments
can be found in the SERvicE section starting on
Page 38.
factory adjustments that should be verified:
tensioning/replacing V-belts (Page 41).
•
Calibrating table elevation scale (Page 47).
•
pulley alignment (Page 42).
•
After approximately 16 hours of operation,
v-belts will stretch and seat into pulley
grooves and need to be properly tensioned
to avoid severely reducing life of v-belts.
Refer to tensioning/Replacing v-belts on
Page 41 for detailed instructions.
G1021X2 & G1021Z (Mfd. Since 08/16)