Cleaning Your Hard Floors - Bissell POWEREDGE 2078 SERIES User Manual

Cleaning Your Hard Floors

NOTE: Before you clean, thoroughly sweep or vacuum fl oor prior to cleaning
with your PowerEdge™ Steam Mop. Your hard fl oor cleaner is designed to
clean hard fl ooring, such as ceramic tile, marble, stone and sealed hard wood
fl oors. Use on waxed or some unwaxed fl oors may result in a diminished
glossiness. The hard fl oor cleaner is not for use on unsealed wood fl oors. For
best results, test in an inconspicuous area and check the care instructions
from your fl ooring manufacturer.
1
Attach mop pad by
wrapping around bottom
of foot, making sure gray
stitching is located on
the front of foot and the
Quick Grip Release Tab is
located on the back.
3
4
When the machine is
plugged in, the READY
light will start to blink.
Step on the back of the
The READY light will turn
foot to recline the body of
to a solid light when the
machine to begin cleaning.
machine is ready to use.
6
To be sure to sanitize an
area of your floor, use the
microfiber cloth pad and
slowly and evenly stroke your
steam mop back and forth
at least three times over the
area using continuous steam.
For best results, remove the
pad and wash after use.
NOTE: Upon the fi rst use of your steam mop or fi rst use after refi lling the
water tank, the pump may make a "knocking" sound. This is normal and will
diminish after a few seconds.
NOTE: The steam mop generates hot steam, so move the unit continuously
when depressing the trigger as damage to fl ooring can occur. The trigger
does not need to be depressed at all times.
2
Plug machine into an outlet.
5
Push the trigger on the
handle to release steam.
7
When done cleaning,
unplug the machine.
7
www.BISSELL.ca