Advertisement
September 2018
3
Consider housing rotation
About this task
To improve field access to wiring or to better view the optional LCD display:
Procedure
1. Loosen the housing rotation set screw.
2. Turn the housing up to 180° left or right of its original (as shipped)
position.
3. Re-tighten the housing rotation set screw.
Figure 3-1: Transmitter Housing Set Screw
Do not rotate the housing more than 180° without first performing a
disassembly procedure (refer to the Troubleshooting chapter in the
appropriate reference manual for more information). Over-rotation
may sever the electrical connection between the sensor module and
the electronics.
3.1
Rotate the LCD display
About this task
Transmitters ordered with the LCD display will be shipped with the display
installed.
In addition to housing rotation, the optional LCD display can be rotated in 90°
increments by squeezing the two tabs, pulling out, rotating and snapping
back into place.
If LCD display pins are inadvertently removed from the electronics board,
carefully re-insert the pins before snapping the LCD display back into place.
Quick Start Guide
A. LCD display
B. Housing rotation set screw (3/32-in.)
CAUTION
Quick Start Guide
13
Hide quick links:
Advertisement
