Step 7: Inserting The Drain Hose Through The Cabinet; Step 8: Slide The Dishwasher Partially Into The Cabinet - Insignia NS-DWH2BS8 Installation Manual

NS-DWH2_BS8_SS8_NS-DWR2_BS8_WH8_SS8_17-0939_Install MAN_V5_ENG.fm Page 15 Wednesday, January 24, 2018 2:49 PM

Step 7: Inserting the drain hose through the cabinet

• Insert the drain hose into the hole in the cabinet wall. If a power cord is used, guide the end through a separate hole.
Tip:
Position the water line and house wiring on the floor to avoid interfering with the base of the dishwasher.

Step 8: Slide the dishwasher partially into the cabinet

Caution:
Do not push against the front panel with your knees. Damage will occur.
1 Position the dishwasher in front of the opening, then slide the dishwasher into the opening a few inches at a time.
2 Pull the drain hose through the opening under the sink as you proceed. Stop when the dishwasher is a few inches in
front of the adjacent cabinetry.
3 Make sure that the drain hose is not kinked under the dishwasher and that there is no interference with the water line,
wiring, or any other component.
Do not push against the
front door panel with your
knees. You will damage the
front panel.
NS-DWH2BS8 / NS-DWH2SS8 / NS-DWR2BS8 / NS-DWR2WH8
Water
line
www.insigniaproducts.com
Maximum drain hose
length 10 ft. (3.01 m)
Drain hose
House wiring
OR
Power cord (if used)
Insulation blanket
15