Enclosure Requirements - Insignia NS-DWH2BS8 Installation Manual

NS-DWH2_BS8_SS8_NS-DWR2_BS8_WH8_SS8_17-0939_Install MAN_V5_ENG.fm Page 5 Wednesday, January 24, 2018 2:49 PM
NS-DWH2BS8 / NS-DWH2SS8 / NS-DWR2BS8 / NS-DWR2WH8
Materials needed (kit purchased separately):
90° Elbow, ferrule and compression nut. (3/8
Three wire nuts (UL listed)
Teflon thread
NPT external thread on one end. Other end
(two included in kit)
seal tape
sized to fit water supply line
New installations only
Strain relief (for
Hot water line (min. Gardenhose
"T" connection
electrical
3/8 in. copper) kit connection
connections)
Not included in kit
Screw-type hose clamps
Waste tee for
Hand shut-off
Electrical cable or power
house plumbing
valve
Coupler for extending
Air gap (if
cord (See Electrical
(if applicable)
drain line (if applicable) required)
Requirements section)

Enclosure requirements

• The dishwasher must be installed so that the drain hose is no more than 10 feet (3.01 m) in length, for proper drainage.
• This dishwasher is designed to be enclosed on the top and on both sides by a standard residential kitchen cabinet unit.
• The installation enclosure must be clean and free of any obstructions.
• The enclosure must be at least 24 inches (61 cm) wide, 24 inches (61 cm) deep, and 34 inches (86.4 cm) high.
• For the front door of the dishwasher to be flush with the front edge of the counter top, the counter top must be 25
inches (63.5 cm) deep.
24" (61 cm)
min.
24" (61 cm)
min.
5
www.insigniaproducts.com