Mitsubishi Electric FX2N-64DP-M Hardware Manual page 42

FX2N-64DP-M Profibus-DP Master Block
5) RADY LED check
Table 5.5: RADY LED Check
State
Lit
Unlit
6) FROM/TO LED check
Table 5.6: FROM/TO Check
State
Lit
Unlit
7) PRM. SET LED check
Table 5.7: PRM. SET LED Check
State
Lit
Flashing
Unlit
64DP-M is in operation mode 0 or E. If it is not in these mode, please contact a service
representative.
64DP-M is not operation mode 0 or E. If it is in these mode, please contact a service
representative.
BFM in 64DP-M is accessed from PLC.
BFM in 64DP-M is not accessed from PLC. Please check program about FROM/TO
instruction.
64DP-M is in operation mode 1.
When this LED is flashing in operation mode 1, there is not parameter in 64DP-M.
Please write parameter to 64DP-M.
64DP-M is in operation mode 0 or E.
Description
Description
Description
Diagnostics 5
5-4