Mitsubishi Electric FX2N-64DP-M Hardware Manual page 14

FX2N-64DP-M Profibus-DP Master Block
f) TEST LED and STATION LED
Table 1.2: TEST LED and STATION LED
LED Name
TEST LED
STATION
LED
g) Hook for mounting DIN rail
h) Profibus-DP communication port
(9-pin D-SUB Connector: #4-40unc inch screw thread)
i) Groove for mounting DIN rail (DIN 46277<DIN rail width: 35mm (1.38")>)
j) DC power supply terminals (screws terminal: M3 )
k) Mode setting switch (Default setting: "0") For mode, refer to Chapter 4.
Table 1.3: Mode Switch
Switch No.
0
1
2
E
~
3 D, F
l) Extension port
ON when self-diagnosis mode is executing.
Displays the station address (Binary) during normal operation. Displays the test
type during self-diagnosis mode. (B0
Mode
ONLINE1 (Normal service mode)
PRM SET (Parameter setting mode)
TEST (Self diagnostic mode)
ONLINE2 (Extended service mode)
Cannot use
Description
~
B6)
Introduction 1
1-4