Connecting To Your Pc; Connecting To Your Pc Using The Usb Cable; Connecting To Your Pc Using The Docking Station - Olympus DS-9500 Instructions Manual

Connecting to your PC

Connecting to your PC using the USB
cable
Boot the PC.
1
2 Connect the USB cable to the USB port
of the PC.
3 Connect the USB cable to the
connecting terminal on the bottom of
the recorder.
• [Remote (Composite)] is displayed on the
recorder if the USB cable is connected.
After connecting the recorder to your PC, it will be
powered through the USB cable.
When connected to a PC, the memory card will be
recognized by the PC as separate removable disk
drives.
NOTE
• NEVER remove the memory card or disconnect
the USB cable while the record indicator light is
flashing. If you do, the data will be destroyed.
• Some PC's may not supply sufficient power and
the recorder fails to connect. Refer to your PC
user's manual regarding the USB port on your PC.
• Do not connect the recorder to a PC by using a
USB hub. Make sure to connect to a USB port on
your PC.
• Make sure to push the cable connector all the
way in. Otherwise, the recorder may not operate
properly.
Connecting to your PC using the
docking station
The docking station is included with the DS-9500,
and sold separately for the DS-9000.
Place the recorder in the docking station
1 Connect the USB cable to the USB port
of the PC.
Connect the USB cable to the docking
2
station as shown in the illustration.
3 Set the recorder in the docking station.
3
• [Remote (Composite)] is displayed on the
recorder if the USB cable is connected.
• If the AC adapter is connected as well, power
will be supplied from the AC adapter.
4
2
EN
51