Pride Mobility Legend Classic 3-Wheel Scooter Owner's Manual page 31

V I I I . D I S A S S E M B L Y A N D A S S E M B L Y
ASSEMBLY
1. Position the front and rear sections of your scooter as
shown in figure 21.
2. Align the lower slots of the front section with the cor-
responding pegs on the front of the rear section.
CAUTION! Position the front-to-rear har-
ness cable so it won’t become pinched
between the frame halves when pivoting
the rear section forward. See figure 22.
3. Holding the seat post, slowly pivot the rear section
forward until the curved locking brackets are fully con-
nected onto the top rear pegs. See figure 22.
4. Raise the tiller.
5. Secure the toggle latch. See figure 17.
n Lower the toggle latch buckle.
n Push back on the toggle latch so it locks into place.
6. Connect the front-to-rear harness.
7. Reinstall the batteries and connect both battery har-
nesses.
8. Reconnect the battery strap .
9. Replace the shroud.
10. Replace the seat, and lock it into place.
Legend Classic/Rev D/August 03
FIGURE 21. FRAME SECTIONS
FIGURE 22. FRAME LOCKUP
www.pridemobility.com
FRONT-TO-REAR HARNESS CABLE
31