Pride Mobility Legend Classic 3-Wheel Scooter Owner's Manual page 30

V I I I . D I S A S S E M B L Y A N D A S S E M B L Y
6. Unplug both black and white 2-pin battery harnesses and remove the batteries. See figure 15.
7. Unplug the front-to-rear harness. See figure 16.
CAUTION!
separating the front and rear sections could result in permanent damage to the scooter.
FIGURE 15. BATTERY HARNESSES
Toggle Latch Release
1. Push in the toggle latch release button while pulling back the toggle latch. See figure 17.
2. Position the toggle latch buckle over the top of the toggle latch. See figure 18.
3. Lower the tiller to the scooter floorboard.
TOGGLE
LATCH
FIGURE 17. TOGGLE LATCH (LATCHED)
Frame Separation
1. Push back on the seat post to pivot the scooter’s rear section rearwards until the rear section is standing
vertically on its rear bumper. See figure 19.
2. Lift the front section up until the lower pegs are no longer in the slots. See figure 20.
3. Carefully move the front section away from the rear section.
FIGURE 19. FRAME POSITIONING
30
Failure to unplug both battery harnesses and the front-to-rear harness prior to
TOGGLE
LATCH
RELEASE
BUTTON
www.pridemobility.com
FIGURE 16. FRONT-TO-REAR HARNESS
TOGGLE
LATCH
BUCKLE
FIGURE 18. TOGGLE LATCH (UNLATCHED)
FIGURE 20. SEPARATING THE FRAME SECTIONS
Legend Classic/Rev D/August 03