Pride Mobility Legend Classic 3-Wheel Scooter Owner's Manual page 23

V . B A T T E R I E S A N D C H A R G I N G
How can I get maximum range or distance per charge?
Rarely will you have ideal driving conditions—smooth, flat, hard driving surfaces with no wind or curves. You will
often face hills, pavement cracks, uneven and loosely packed surfaces, curves, and wind. All of these driving conditions
affect the distance or running time per battery charge. Below are a few suggestions for obtaining the maximum range
per battery charge.
n Always fully charge your scooter’s batteries prior to your daily use.
n Maintain 30-35 psi in all of your scooter tyres.
n Plan your route ahead to avoid as many hills, cracked, broken, or soft surfaces as possible.
n Limit your baggage weight to essential items.
n Try to maintain an even speed while your scooter is in motion.
n Avoid stop-and-go driving.
What type and size of battery should I use?
We recommend deep-cycle batteries that are sealed and maintenance free. Both sealed lead-acid and gel cell are
deep-cycle batteries that are similar in performance. Do not use wet-cell batteries, which have removable caps.
CAUTION! Do not remove the caps from sealed batteries. Water cannot be added to sealed batter-
ies. Cap removal voids the battery warranty and may cause damage to the batteries and to your
scooter.
Use these specifications to reorder deep-cycle batteries:
Type: Deep-cycle (sealed lead-acid or gel cell)
Size: U-1, 32 AH
Voltage: 12 volts each
Amperage: 32 AH (amp hours)
To change a battery in your scooter:
WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds.
Wash hands after handling.
1. Remove the seat and the rear shroud. See VIII. “Disassembly and Assembly.”
2. Disconnect the battery strap.
3. Disconnect the 2-pin, black and white battery harness from its mating plug. See figure 15 in VIII. “Disassembly
and Assembly.”
4. Disconnect the battery cables from the battery terminals.
5. Remove the old battery.
6. Place a new battery in the battery well.
7. Connect the red battery cable to the positive (+) battery terminal.
8. Connect the black battery cable to the negative (-) battery terminal.
9. Reconnect the 2-pin, black and white battery harness to its mating plug.
10. Reconnect the battery strap.
11. Reinstall the rear shroud and seat.
Why do my new batteries seem weak?
Deep-cycle batteries employ a different chemical technology than that used in car batteries, nickel-cadmium batteries
(nicads), or in other common battery types. Deep-cycle batteries are specifically designed to provide power, drain
down their charge, and then accept a relatively quick recharge.
Legend Classic/Rev D/August 03 www.pridemobility.com
23