English
28
Warning icons and error codes
What to do if the descaling procedure is interrupted
Once the descaling procedure has started, you must complete it
till the very end without switching off the machine. If the machine
gets stuck during the cycle, you can exit the descaling procedure by
pressing the standby button.
If this occurs, or in case of a power failure or accidental
disconnection of the cord, do the following:
1 Turn off the machine.
2 Empty and rinse the water tank thoroughly.
3 Fill the water tank up to the CALC CLEAN level indication and
turn the machine back on.
-
The machine will heat up and perform an automatic
rinsing cycle.
4 Before brewing any beverages, perform a manual rinsing cycle
(see ‚Manual rinsing cycle').
Note: If the descaling procedure was not completed, the machine
will require another descaling procedure as soon as possible.
The warning icons are displayed in red. Below you find a list of the
warning icons that may appear on the display and their meaning.
- Fill the water tank with fresh water to the MAX level indication.
- The bean hopper is empty. Put new coffee beans in the bean
hopper.
- The brew group is not in the machine or it is not inserted
properly. Insert the brew group.
- Insert the drip tray.