Table of Contents
Advertisement
Navigation Keys and Status LEDs: The Navigation keys
and Status LEDs are detailed in the following table.
1
Com.
2
On
3
Warn.
4
Alarm
1
Com. LED: Flashes when bus communications is
communicating.
2
Green LED/On: Control selection is working.
3
Yellow LED/Warn.: Indicates a warning.
4
Flashing Red LED/Alarm: Indicates an alarm.
Arrows YB: Use the Up and Down arrow keys
5
to navigate between parameter groups, parameters
and within parameters. Also used for setting local
reference.
6
Back key: Press to move to the previous step or
layer in the navigation structure.
7
OK key: Press to select the currently displayed
parameter and for accepting changes to parameter
settings.
Operation Keys and LEDs: The following table details the
functions of the Operating keys. An illuminated yellow LED
above the key indicates the active key.
Hand
On
1
1
Hand On key: Starts the motor and enables
control of the variable frequency drive (VFD) via
the VFD Keypad option.
NOTE: Please note that terminal 27 Digital Input
(5- - 12 Terminal 27 Digital Input) has coast inverse
as default setting. This means that the Hand On
key will not start the motor if there is no 24V to
terminal 27, so be sure to connect terminal 12 to
terminal 27.
Off/Reset key: Stops the motor (off). If in alarm
2
mode the alarm will be reset.
Auto On key: The variable frequency drive is
3
controlled either via control terminals or serial
communication.
Connecting the Keypad to the VFD
The VFD keypad can be mounted directly to the variable
frequency drive, provided you can easily access the front
panel of the VFD. If you do not have easy access to the
VFD front panel, use the cable included with the kit to
connect the keypad to the VFD.
Connecting the Keypad Directly to the VFD —
1. Place the bottom of the VFD keypad into the variable
frequency drive as shown in Fig. 61.
5
6
OK
7
5
Off
Auto
Reset
On
2
3
C13114
Fig. 61 - - Align Bottom of VFD Keypad with Opening
2. Push the top of the VFD keypad into the variable fre-
quency drive as shown in Fig. 62.
C13115
Fig. 62 - - Secure Keypad in Place
Using the Cable to Connect the Keypad to the VFD —
The VFD keypad can be connected to the variable
frequency drive via the cable included with the
Multi- - Speed VFD display kit (PN: CRDISKIT002A00).
1. Connect the male end of the cable to the front panel
of the variable frequency drive. Use 2 of the screws
included with the kit to secure the cable to the VFD.
2. Connect the female end of the cable to the back panel
of the VFD Remote keypad. Secure the cable to the
remote keypad using the 2 remaining screws from the
kit.
56
in VFD Front Panel
C13116
C13117
Advertisement
Table of Contents
