How To Connect Gas Line - Magic Chef MCSRG24S Installation Manual

• Failure to follow these instructions can result in death or serious burns to children and adults�
IMPORTANT: DO NOT completely remove the rear leveling leg� The anti-tip bracket uses either the right-hand
or left hand, rear leveling leg to secure the range to the floor�
1� Remove the anti-tip bracket from where
it is taped inside the range�
2� Determine and mark the centerline of the
opening� (Refer to Figure 10�)
NOTE: The anti-tip bracket can be installed
on either side of the opening (left or right)�
3� Measure 17 ½" (53�5cm) out from the
centerline and 5" (12�7cm) out from the
back wall� (Refer to Figure 10�)
4� Drill two 1/8" (3mm) holes through the
mounting holes in the anti-tip bracket
and into the floor�
5� Using the two screws
the anti-tip bracket to the floor� (Refer to
Figure 11 for 3 different securing options�)
Front Position

HOW TO CONNECT GAS LINE

WARNING: Explosion Hazard
• Use a new CSA International approved gas supply line�
• Install a shut-off valve�
• Securely tighten all gas connection�
• If connected to LP, have a qualified technician make sure gas pressure does not exceed 14" (36cm) water
column�
• Examples of a qualified technician include: licensed heating personnel, authorized gas company personnel,
and authorized service personnel�
• Failure to do so can result in death, explosion or fire�
How to Install Typical Flexible Connection (Refer to Figure 12�)
1� Apply pipe-joint compound made for use with NG (natural gas) to the male threads of the adapter�
2� Insert adapter into outlet of the gas pressure regulator, and then tighten using two 10" adjustable wrenches�
Be sure flow arrow on regulator is pointing up toward the range gas inlet pipe�
provided, secure
Rear Position
12
Figure 10
5" (12�7cm)
17-1/2"
(53�5cm)
Figure 11
Diagonal Position