Replacing The Hard Drive; Procedure - Dell G3 15 Service Manual

Enable Intel Optane after replacing the SATA storage. For more information about enabling the Intel Optane, see
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
CAUTION: Hard drives are fragile. Exercise care when handling the hard drive.

Procedure

1 Place the hard-drive bracket on the hard drive and align the screw holes on the hard-drive bracket with the screw holes on the hard
drive.
2 Replace the four screws (M3x3) that secure the hard-drive bracket to the hard drive.
3 Connect the interposer to the hard-drive assembly.
4 Align the screw holes on the hard-drive assembly with the screw holes on the palm rest and keyboard assembly.
5 Replace the two screws (M2x3) that secure the hard-drive assembly to the palm rest and keyboard assembly.
6 Fold the hard-drive cable and connect it to the system board.
7 Slide the hard-drive cable into the connector on the system board and close the latch.
38

Replacing the hard drive

Replacing the hard drive
computer. After working inside your computer, follow the instructions in
20
Enabling Intel Optane.
After working inside
www.dell.com/