Samsung SNK-D85121BF User Manual page 25

Alarm
Motion
Go to "Main Menu" ; "Parameter" ; "Network" ; "Motion" to enter into the interface.
• Channel: Enable or disable Motion function.
• enable: Enables the use of a switch.
• sensitivity: Support 1-8 level, 8 is the highest level.
• Buzzer: When detecting object moving, an alarm is turned on
(disable, 10 seconds, 20 seconds, 40 seconds and 60 seconds).
• show Message: Messages will be displayed on the screen when a moving
object is detected and alarms are enabled.
• send email: When a moving object is detected, an email will be sent to the
address entered.
• full screen: When a moving object is detected, a message will be displayed
in full screen.
• post recording: The duration time of the alarm recording can be set as 30 seconds, 1 minute, 2 minutes and 5 minutes.
• Area: Set the specific area(s) in the camera's field of view to monitor for
motion. A single channel is divided into 44x30 (PAL) or 44x30 (NTSC)
configurable grids. The red grids indicate that the motion detection in the
selected area is enabled.Semitransparent boxes meansmotion detection in
that area is disabled. Once you set your motion alert preferences, right click
the mouse button to return and click Save to make the setting effective.
• record Channel: When object motion is detected, the record channel
setting will be activated.
Alarm Type
Video Loss
Motion Detection
HDD Status
When the NVR fails to receive video signals due to some problems (camera damage, line dropout or damage,
power failure), the alarm will appear.
When IP camera detects object moving, alarm will be activated. Sensitivity is subject to the actual application
environment test. Sensitivity is adjusted according to the sensitivity of the moving object detectedand parameters
set in the setting.
Alarm will appear when HDD does not work due to damage, power failure, HDD auto-overwrite off and
insufficient space.
Functions & Descriptions
English _25