(1) Zoom Preset Operation
In this operation, the zoom moves to a predetermined position by pressing a switch.
■ Setting Zoom Preset Operation Mode
a.
Set the preset ON/OFF switch (refer to page 18) to ON.
(The switch has been set to ON at the factory.)
b.
Set the function switch (refer to page 19) to OFF.
(The switch has been set to OFF at the factory.)
c.
Set the quickframe/manual zoom select knob to "ON."
■ Storing Preset Position
a.
Set the zoom position by operating the zoom seesaw control lever.
b.
While pressing the preset switch (MEMO), press the preset switch (ON).
■ Recalling Preset Shot
Press the preset switch (ON).
-
The zoom will move to the predetermined position then stops.
(During this operation, the shot recalling speed can be changed by means of the zoom maximum speed
control knob.)
(2) Zoom and Focus Simultaneous Preset Operation
In this operation, the zoom and focus move to their predetermined positions simultaneously by pressing a switch.
■ Installation of Optional Accessories
For zoom and focus simultaneous preset operation, the following accessory is required.
Install it on the lens referring to its operation manual.
・ Focus Position Demand Unit
(EPD-4A-E01 or EPD-4A-E02)
■ Setting Zoom and Focus Simultaneous Preset Operatoin Mode
a.
Set the preset ON/OFF switch (refer to page 18) to ON.
(The switch has been set to ON at the factory.)
b.
Set the function switch (refer to page 19) to ON.
c.
Set the quickframe/manual zoom select knob to "ON."
d.
Set the focus servo/manual select knob to "S."
■ Storing Preset Position
a.
Setting Zoom Position
Set the zoom position by operating the zoom seesaw control lever of the lens.
b.
Setting Focus Position
Set the focus position by operating the focus control knob of the Focus Position Demand Unit.
c.
While pressing the preset switch (MEMO) of the lens, press the preset switch (ON).
Note. This function will not operate when the focus servo/manual select knob is set to manual.
■ Recalling Preset Shot
Press the preset switch (ON) of the lens.
-
The zoom and focus move to their predetermined positions then stop.
The zoom and focus start and stop simultaneously.
(During this operation, the shot recalling speed can be changed by means of the zoom maximum speed
control knob.)
- 15 -