Winding The Bobbin; Inserting The Bobbin - Shark 412N Instruction Manual

Winding the bobbin

Place empty bobbin on winding spindle ,and place spool on the spool pin.
Wind thread a few times by hand round the empty bobbin in a clockwise
direction . press the foot control till the bobbin full. Remove the bobbin by
cutting the thread with cutter.
1
2
3
4

Inserting the bobbin

When inserting or removing bobbin, the needle must be fully raised.
Open the hook cover:
insert the bobbin in the bobbin case, so that the thread runs in a clockwise
direction.
Attention: Turn power switch to "off" position !
5
Zigzag/Overlock stitching
1.There are 4 patterns of zigzag for selecting . Turn the pattern selector
dial to the stitch trace you need(4 - 7).
Thread tension for
zigzag stitch
Back
side
Right side
Zigzag foot
Notice :
1.When turning the pattern selector dial, assure the needle tipis at the
upper position, otherwise, it will be bent or damaged ,or fail to sewing
2.When selecting the pattern dial, set the position corectly, otherwise,
it will hurt the needle ,or sew over the selected stitch trace. It will be
different from the selected pattern.
Pattern selector dial
4 5 6 7
10