Checking - Samsung L710 Owner's Instruction Book

Troubleshooting

Checking

If you run into any problem using the camcorder, use the following table to troubleshoot the problem.
If these instructions do not allow you to solve the problem, take a note of:
The model and serial number marked on the bottom of the camcorder.
Your warranty, if applicable.
Then contact your nearest authorized service center.
Symptom
You cannot switch the Check the battery pack (see page 23)
camcorder on. or the AC power adapter. (see page 22)
Start/Stop does not Check the POWER, set it to CAMERA.
operate while recording You have reached the end of the cassette.
Check the record protection tab on the cassette. (see page 26)
The camcorder goes You have left the camcorder set to STANDBY
off automatically. for more than 5 minutes without using it.(see page 28)
The battery pack is fully used up. (see page 25)
The battery pack is The atmospheric temperature is too low. (see page 25)
quickly exhausted. The battery pack has not been charged fully.(see page 23)
The battery pack is completely dead, and cannot be recharged.
Use another battery pack.
You cannot eject the The battery pack is fully used up.
cassette from the A mechanical fault might have occurred. (see page 68)
compartment.
The DATE/TIME indicator The lithium battery is not installed or is fully used up. (see page 21)
flashes more than 2 times
when you set the
camcorder to CAMERA.
The playback picture The video heads might be dirty. (see page 66)
is poor.
You cannot operate any A mechanical fault might have occurred (see page 68).
functions on the camcorder.
Explanation/Solution
ENGLISH
69