ENGLISH]
Troubleshooting
Checking
+
If you run _ntoany problem using the cacncorder, use the following table to troubleshoot the problem
+
If these instructions do not allow you to solve the problem, take a note of
•
The model and serial number marked on the bottom of the camcorder
•
Your warranty d applicable
+
Then contact your nearest authorized serwce center
Symptom
Explanat=on/Sotutton
You cannot switch the
•
Check the battery pack _see page 221
camcorber on
or the AC power adapter (see page 21]
Start/Stop does not
•
Check the power set it to CAMERA
operate wh4e recording
•
You have reached the end of the cassette
•
Check the record protection tab on the cassette (see page 251
The camcorder goes
•
You have left the car'ncorber set to STANDBY
off automatically
for more than 5 minutes without using it ['see page 27]
•
The battery pack is fully used up {see page 241
The battery pack is
•
The atmospheric temperature is too low q see page 24_
quickly exhausted
•
The battery pack has not been charged fully ['see page 22)
•
The battery pack is completely dead, and cannot be recharged
Use another battery pack
You cannot eject the cassette
•
The battery pack is fully used up
from the compartment
•
A mechanical fault m,ght have occurred i see page 581
The DATE/TIME indicator flashes
•
The I,thlum battery ,s not installeb or Is fully useb up Isee page 20)
more than 2 t_mes when you
set the car'qcorder to CAMERA
The prayback picture is poor
•
The wbeo heads might be dirty Isee page 56_
You cannot operate
•
A mechanical fault m,ght have occurred i see page 58)
any funct,ons on the camcorder
A