Adjusting The Lcd; Setting The Speaker On/Off; Dse In Player Mode - Samsung L710 Owner's Instruction Book

ENGLISH
Playing back a Tape

Adjusting the LCD

The LCD control in PLAYER mode is identical to step 3 of page 30, except the power switch must be
set to PLAYER mode.

Setting the Speaker ON/OFF

The speaker is turned ON/OFF by opening/closing the LCD.
The speaker ON/OFF setting operates when the LCD is opened.
When it is set to OFF, the speaker won't turn on even after opening
the LCD.
1. Set the power switch to PLAYER mode.
2. Press the MENU ON/OFF button,
then the MENU list will appear.
3. Turn the UP/DOWN dial to SPEAKER.
4. Press ENTER to switch the selection.
5. Press the MENU ON/OFF button again to end the SPEAKER setting.
Volume control
Speaker volume can be controlled by turning
the MENU dial during playback.
Note: When the MENU list is on, volume will not be changed.

DSE in PLAYER mode

The procedure for using DSE in PLAYER mode is the same as the procedure for using DSE in CAMERA mode,
except that the power switch must be set to PLAYER instead of CAMERA. Please refer to pages 44 and 45.
Note: The GHOST, STROBE, NEG., MIRROR, MOSAIC, CINEMA and 16:9(WIDE) effects will not operate when your
camcorder is in PLAYER mode.
Pressing the DSE button will scroll through the available settings.
Stop at the one you require.
60
MENU
LCD ADJUST
SPEAKER ............ON
DISPLAY ..............ON
PAL CONV. ..........OFF
WL.REMOCON ....ON
C.RESET ..............0:00:00
EXIT: MENU
MENU
LCD ADJUST
SPEAKER ............OFF
DISPLAY ..............ON
PAL CONV. ..........OFF
WL.REMOCON ....ON
C.RESET ..............0:00:00
EXIT: MENU