Miscellaneous Settings - HHB PORTADRIVE PDR2000 Operation Manual

Further pages are available by pressing the MORE key on F6:
The first of these is the MISC page where you can set miscellaneous parameters that affect operation
of the unit. They are:
PRE-RECORD BUFFER
From 'buffer'
Version 1.31
When you start recording, it is possible by using the PRE –RECORD
BUFFER to actually record information up to 10 seconds before the
recording was started. When the PORTADRIVE is in STOP mode a
solid state buffer memory is used to constantly store the incoming
audio data, so that when recording is activated the data from this
buffer is written to the disk at the beginning of the recording.
The PRE-RECORD BUFFER can be set to a value of 0 to10 seconds
when operating at a sample frequency of up to 48kHz, and 0 to 5
seconds when operating at a sampling frequency over 48kHz.
Press
RECORD
TAKE 'XYZ'
On disk
TOP PANEL MODES
103