When Using Nfc - Nikon KeyMission 360 User Manual

When Using NFC

1
Prepare for pairing (A13).
2
Close all apps that use NFC (including SnapBridge 360/170).
Pairing may fail if apps that use NFC are running.
3
Press and hold down the movie button
(about 7 seconds) on the camera.
Press and hold down the movie button until the
status lamps flash green at the same time, even if
you hear the startup sound.
The status lamps flash green at the
same time for a while and then
alternately flash green (the camera is
in pairing standby mode).
4
Touch the NFC antenna of the smart device to the Y (N-Mark)
(A1) on the camera.
SnapBridge 360/170 launches.
5
When Switch pairing to the camera you just touched? is
displayed, tap OK.
If pairing is successful, the screen shown on the right is
displayed.
If pairing fails, the status lamps flash red six times at the
same time. When a message indicating that pairing has
failed is displayed on the screen, tap OK and repeat the
pairing procedure by following "When You Cannot Pair
with a Smart Device" (A18).
16
Using SnapBridge 360/170
Connect
KeyMission 360