Switching The Paper Roll - VeriFone VX675 CTLS Manual

Changing the paper roll
1
2
3
4
A special thermal paper roll with a width of 57 mm and a
diameter of up to 50 mm is used in the terminal.
When the paper roll is nearing its end, a coloured indicator
strip becomes visible indicating that the printer is about to
run out of paper. If the strip appears, it means that the
printer has enough paper for one more receipt.
First press the key on the side of the terminal
to open the paper roll cover and lift it up as shown on the
illustration. Remove the empty paper roll from the printer
Slightly unwind the new paper roll and remove the
protective strip from the edge, if required.
Place the new paper roll so that the paper moves from
the bottom of the roll towards the front edge. Leave
a small amount of paper to extend outside the printer door.
Close the terminal cover by pressing it gently until it clicks.
A small amount of paper must extend outside the printer.
Cut the paper with the metal strip on the printer.
Attention!
Poor quality paper can jam the printer and create excessive
paper dust. Thermal paper must be stored in a dry and dark
place. Moisture, temperature, friction, liquids, etc. can affect
the characteristics of the paper. Do not place a paper roll
with wrinkled, wet or damaged paper in the printer.
17