Activate A Dc Power Supply Module; Port Connection Guidelines - Cisco NCS 540 Hardware Installation Manual

Activate a DC Power Supply Module

Figure 9: Attach the DC Power Supply Wires
Activate a DC Power Supply Module
Perform the following procedure to activate a DC power supply:
Step 1
Remove the tape from the circuit-breaker router handle, and restore power by moving the circuit-breaker router handle
to the On (|) position.
Step 2
Verify power supply operation by checking if the respective power supply front panel LED (PS0 or PS1) is green.
Step 3 If the LEDs indicate a power problem, see Troubleshooting.
Step 4
If you are connecting a redundant DC power supply, repeat these steps for the second power source.
Note If you are connecting a redundant DC power supply, ensure that each power supply is connected to a separate
power source in order to prevent power loss in the event of a power failure.

Port Connection Guidelines

Depending on the chassis and installed line cards, you can use Quad Small Form-Factor Pluggable Plus
(QSFP+), QSFP28, SFP, SFP+, and RJ-45 connectors to connect the ports on the line cards to other network
devices.
Cisco NCS 540 Router Hardware Installation Guide
26
Install the Device