Installing A Dc Power Supply Module; Installing Dc Power Supply Unit (A900-Pwr550-D) - Cisco ASR 902U Hardware Installation Manual

Hide thumbs Also See for ASR 902U:

Table of Contents

Installing the Cisco ASR 902 Router

Installing a DC Power Supply Module

Perform the following procedure to install a power supply module:

Step 1

Ensure that the system (earth) ground connection has been made. For ground connection installation instructions, see

the

Installing the Chassis Ground

Step 2

If present, remove the blank power supply filler plate from the chassis power supply bay opening by loosening the captive

installation screws.

Step 3

Verify that power to the DC circuit connected to the power supply you are installing is off. To ensure that power has

been removed from the DC circuits, locate the circuit breakers for the DC circuits, switch the circuit breakers to the OFF

position, and tape the circuit-breaker switches in the OFF position.

Step 4

Grasp the power supply handle with one hand. Place your other hand underneath the power supply, as shown in the

figure below . Slide the power supply into the power supply bay. Make sure that the power supply is fully seated in the

bay.

Figure 47: Installing a DC Power Supply

Step 5

Tighten the captive installation screws of the power supply. The recommended maximum torque is 5.5 in.-lb (.62 N-m).

If you are installing a redundant DC power supply, repeat these steps for the second power source too.

Perform the following procedure to install the terminal block.

Step 1

Locate the terminal block plug.

Step 2

Use a wire-stripping tool to strip the ends of each of the two wires coming from the DC-input power source to 0.27 inch

(6.6 mm) ± 0.02 inch (0.5 mm) and the wire for grounding. Do not strip more than 0.29 inch (7.4 mm) of insulation from

Connection.

Cisco ASR 902 and ASR 902U Aggregation Services Router Hardware Installation Guide

Installing a DC Power Supply

Table of Contents

Asr 902