Controlling Your Tv; I Have The Code For My Tv; There Are Several Codes For My Tv - EchoStar HDT-610R User Manual

Controlling your TV

The HDT-610R remote control has a number of buttons that can be used to
control your TV. These are:
Volume up/down Mute TV On/Standby
To be able to use these buttons, your HDT-610R's remote needs to be
programmed with a 4-digit code. This identifies the correct signals for your TV.
the appropriate codes for your TV. An extensive list of codes covering the
majority of TV models is included at the back of this manual - see page 47.

I have the code for my TV

To program the remote:
1. Hold down both the CH+ and VOL- keys simultaneously for at least 2
seconds. The blue LED gives two slow flashes to indicate successful entry
into the setup mode.
2. Using the numbered keys, enter the 4 digit code within 30 seconds. The
LED will flash for each entry.
3. After the fourth digit entry, the blue LED gives two slow flashes to indicate
that the code has been successfully programmed.
In the event of an error, the LED gives four rapid flashes. If this occurs, you will
need to repeat this process.

There are several codes for my TV

Where several codes are listed by a manufacturer, it may be necessary to
repeat the above sequence with each code until the correct one is found.
18
TV source