Sony PMW-200 Service Manual page 69

2. Remove the bottom cover. (Refer to
3. Remove the inside panel assembly. (Refer to
4. Remove the outside panel assembly. (Refer to
5. Remove the top panel assembly. (Refer to
6. Remove the SxS slot assembly. (Refer to
7. Remove the front panel assembly. (Refer to
8. Remove the rear panel assembly. (Refer to
9. Remove the IO-255 assembly. (Refer to
10. Remove the main heat spreader DCP. (Refer to
11. Remove the handle assembly. (Refer to
12. Remove the front lens assembly. (Refer to
Procedure
1. Remove the six screws to detach the BI retainer bracket.
BI retainer bracket
P2 x 4
P2 x 4
2. Remove the harness and three fine-wire coaxial cables from the six claws.
3. Disconnect the two BI boards from the two connectors CN100, CN200 on the HN-399 board.
4. Remove the two screws.
PMW-200/PMW-EX280
"2-3. Bottom Cover and Tripod
"2-4-1. Inside Panel
"2-5-1. Outside Panel
"2-6. Top Panel
"2-7-1. SxS Slot
"2-8-1. Front Panel
"2-9. Rear Panel
"2-11. IO-255 Board".)
"2-12. DCP-56
"2-13-1. Handle Assembly".)
"2-14-1. Front Lens
P2 x 4
P2 x 4
Washer".)
Assembly".)
Assembly".)
Assembly".)
Assembly".)
Assembly".)
Assembly".)
Board".)
Assembly".)
2-39