Chapter 1 Getting Ready; Names Of Machine Parts - Baby Lock Jubilant BL80B Instruction And Reference Manual

1
Chapter

Names of Machine Parts

■ Main parts
c
a
n
m
l
k
o
x
w
v
1 Bobbin winding thread guide and pretension disk
(page 13)
2 Thread guide (page 12)
3 Spool cap (page 12)
4 Spool pin (page 12)
5 Hole for extra spool pin
This holds an extra spool pin for sewing with twin needle. (page
49) This is not a hole for lubrication. Do not insert oil into this
hole.
6 Bobbin winder (page 12)
7 LCD (liquid crystal display) (page 10)
8 Operation keys (page 6)
9 Stitch pattern selection dial (page 23)
0 Operation buttons and sewing speed controller
(page 6)
A Flat bed attachment (page 7, 29)
B Thread cutter (page 17)
C Needle threader lever (page 17)
D Thread tension dial (page 27)
E Handwheel
Turn the handwheel toward you (counterclockwise) to raise and
lower the needle to sew one stitch.
F Thread guide cover (page 12)
GETTING READY
e
f
g
h
i
j
q
s
t
u
G Handle
Carry the machine by its handle when transporting.
H Presser foot lever
Raise and lower the presser foot lever to raise and lower the
presser foot.
I Feed dog position switch
Use the feed dog position switch to raise and lower the feed
dogs. (page 46)
J Main power switch (page 9)
K Power supply jack (page 9)
L Foot controller (page 24)
M Foot controller jack (page 24)
N Air vent
The air vent allows the air surrounding the motor to circulate.
Do not cover the air vent while the machine is being used.
■ Needle and presser foot section
i
h
g
f
e
1 Needle bar thread guide (page 16)
2 Needle plate (page 30)
3 Needle plate cover (page 14)
4 Bobbin cover/bobbin case (page 14, 54)
5 Feed dogs
The feed dogs feed the fabric in the sewing direction.
6 Presser foot
The presser foot applies pressure consistently on the fabric as
the sewing takes place. Attach the appropriate presser foot for
the selected stitch.
7 Presser foot holder (page 22)
8 Presser foot holder screw (page 22)
9 Buttonhole lever (page 40)
Names of Machine Parts
c
5
1